Container And Liner of Aluminum Extrusion Press

Container And Liner is the part of aluminum extrusion press.

Special order also is available.

Extrusion container temperature is very important: and pay more attention on the pre-heating up temperature to avoid excessive thermal stress between the layers, it is preferable that the extrusion outer cover and bushing simultaneously raised to the operating temperature. Preheat heating rate of not greater than 38 ℃ / h. The best warm-up specifications is: heat up to 235 ℃, holding 8h, continue to heat up to 430 ℃, holding 4h, and then come into run and work. This will not only ensure uniform temperature inside and outside, and there is enough time to eliminate all internal thermal stresses. And sure that it is a good method to heat the container in an oven.