Home > News And Knowledge > Extrusion Knowledge > The clean method of hydraulic oil reservior of aluminum extrusion press

Extrusion Knowledge

The clean method of hydraulic oil reservior of aluminum extrusion press

The clean method of hydraulic oil reservior of aluminum extrusion press
 
The hydraulic oil just like the person blood spreads over the hydraulic system of aluminum extrusion press. As years increasing, the dust or impurities will accumulate in the hydraulic oil box (reservoir) and flow through the pump, valve and heat exchanger, it will influence the working condition or working life of pump, valve and heat exchanger. So when the machine is free, cleaning the oil reservoir is good for aluminum extrusion maintenance. The clean method of hydraulic oil reservior of aluminum extrusion press as follow:
1.Drain the hydraulic oil out from the oil box.
2.Use the diesel to clean the oil box, (make sure there is no any fire)
3.Use the clean cloth to wipe dry the oil box. (Must be clean cloth, make it to small pieces for better.).
4.Roll the flour powder, use the flour paste to dry the oil box.
5.Use clean cloth to dry the oil box again. Then finish.
6.Tips: use some magnet to install at the location of oil inlet or outlet, it can stick to the iron or other impurities.
Clean oil reservoir, clean hydraulic oil will be beneficial to hydraulic pump, valve and heat exchanger working life.
This is original article, edited by Judy Wei. Please indicate the source if you reprint.

Previous   [Return Home] [Print] [Go Back]   Next

Contact Us

: 575645529